Sticker applicator.

This product’s sticker machine is a new generation of early childhood educational toy. It can apply a layer of adhesive to colored stickers, DIY patterns, or small plastic accessories, allowing them to be attached to various small objects, adding to the fun. 1.2. The components of the sticker machine include: sticker machine decorative back panel, sticker main unit, triangular plastic card, colored stickers, transparent adhesive film, removable double-sided adhesive, shaft, plastic accessories, and other components. 1.3 The decoration back panel of the sticker machine. The doors on either side can swing forward and backward by approximately 90 degrees. There are raised circular catch points on the sides of the doors, which can be used to hang small items. The rotating positions of the doors are circular studs. The structure features removable door panels, with a force range of approximately 3 to 8 LBS for installation and removal. 1.4. The sticker host can be mounted on the back panel of the sticker machine. Align the two circular recessed holes on the back of the sticker host with the two raised pin posts on the back panel. Then press down and gently push it to the right until it clicks into place. A simple click, and it’s securely fastened. 1.5. The sticker-equipped main unit features a removable front cover. When opened to a 90-degree angle upward, the cover edge slides into the main unit’s card slot and locks in place. The red back cover can be opened and closed; when opened downward, it can be held in place by a latch. Both the front and rear covers can be easily removed and reinstalled. The force required for removal and installation is approximately 3–8 LBS. The drawer at the bottom of the main unit can be manually pulled out by about 20 mm, and when pushed back to the bottom, the sides of the drawer will be secured by clips. The force required for pushing and pulling is approximately 3–8 LSBs. 1.6. How to use the sticker applicator: Follow the instructions to install the paper roll and the transparent paper roll in their respective positions. Take out the stickers or plastic accessories you need to apply adhesive to, and insert them into the back of the sticker applicator, following the arrow direction. Rotate the knob in the direction of the arrow. Observe as the entire sticker or paper frame emerges from the front exit point, indicating that the adhesive has been applied. Then, simply cut out the desired sticker or paper frame.

This product’s sticker machine is a new generation of early childhood educational toy. It can apply a layer of adhesive to colored stickers, DIY patterns, or small plastic accessories, allowing them to be attached to various small objects, adding to the fun. 1.2. The components of the sticker machine include: sticker machine decorative back panel, sticker main unit, triangular plastic card, colored stickers, transparent adhesive film, removable double-sided adhesive, shaft, plastic accessories,